| 
Pose tended ceilings Clipso
|
|
|
CW frame :
|
| The CW frame (Clipso wall) is fixed directly
to the wall, at the desired height (figure 01).
Cut the frames to the right length, using a mitre-cutting
saw for the corners (figure 02).
Fixing on a wood surface :
| |
• screw the frame directly onto
the wood support using wood screws (size 4x20)
|
|
| Fixing to “plasterboard, plaster+brick,
concrete and metal” supports :
| |
• spread a continuous, even layer
of contact adhesive on the CW frame ;
• place the frame coated with contact adhesive
in the desired position ;
• remove the frame and leave it to dry for 5 to
10 minutes (depending on the type of adhesive) ;
• put the frame back into the desired position,
using pressure (readjust if necessary) ;
• screw the frame using 5.5x38 size screws on “plasterboard”
supports ;
• drill 6 mm diameter holes, then use rawplugs
with screws on “brick” supports ;
• drill 6 mm diameter holes, then use dowels and
nails on “concrete” supports ;
• self-tapping screws (on metal supports).
|
|
|
| Note : one screw every
15cm, on pre-drilled frames.
|
|
|
CC frame :
|
|
| The CC frame (Clipso ceiling) is fixed directly
onto the existing ceiling (figure 03).
Cut the frames to the right length, using a mitre-cutting
saw for the corners (figure 04).
Fixing to a wood surface :
| |
• screw or staple the frame directly
onto the support using wood screws (size 4x20), with
one screw every 30cm.
|
Fixing to “plasterboard, plaster+brick, concrete
and metal” supports:
| |
• spread a continuous, even layer
of contact adhesive on the CC frame ;
• place the frame coated with contact adhesive
in the desired position ;
• remove the frame and leave it to dry for 5 to
10 minutes (depending on the type of adhesive) ;
• put the frame back into the desired position,
using pressure (readjust if necessary) ;
• screw the frame using 5.5x38 size screws on “plasterboard”
supports ;
• drill 6 mm diameter holes, then use rawplugs
with screws on “brick” supports ;
• drill 6 mm diameter holes, then use dowels and
nails on “concrete” supports ;
• self-tapping screws (on metal supports).
|
|
| Note : use an extra screw close
to the frame joints (figure 05)
 Take
care not to fix the frame in a place that cannot
be easily accessed later on with the spatula.
|
|
|
|
|
|
|
|
